Timberwolf Entec 230DH, Руководство пользователя

Страница: 10 / 50

OPERATING INSTRUCTIONS
9
DELIVERY
All Timberwolf 75/230DH machines have a full pre - delivery inspection before leaving the factory and
are ready to use. Read and understand this instruction manual before attempting to operate the
Chipper. In particular, read pages 5-7 which contain important health and safety information and
advice.
OPERATOR’S PERSONAL PROTECTIVE EQUIPMENT REQUIRED
CHAINSAW safety helmet fitted with visor and
recommended ear defenders to an appropriate
specification.
HEAVY-DUTY gloves.
CLOSE - FITTING heavy-duty non-snag clothing.
SAFETY footwear.
FACE MASK (if appropriate).
MANUAL CONTROLS
Do not rely on the red bar to keep the rollers stationary if it
is necessary to clear or touch the rollers. Always switch off
the machine before approaching the rollers.
GREEN FORWARD
FEED BUTTON
BLUE REVERSE
FEED BUTTON
RED STOP FEED -
EMERGENCY STOP
BUTTON
RED SAFETY BAR
Control Panel Diagram
fig 5.
Roller control box - is the control box above the feed opening of the chipper funnel. Its function is to control
the feed rollers. The feed rollers draw material into the machine.
It does not control the main rotor.
RED SAFETY BAR = This is the large red bar that surrounds the feed tray and side of the feed funnel.
The bar is spring loaded and connected to a switch that will interrupt the power to the rollers. The
switch is designed so that it only activates if the bar is pushed to the limit of its travel. The rollers stop
instantly, but can be made to turn again by pressing either the GREEN FEED or BLUE REVERSE
control buttons.
RED SAFETY BAR TEST
To ensure the safety bar is always operational it must be activated once before each work session.
The rollers will not function until the bar is activated. This procedure must be repeated each time
the ignition is switched off.
GREEN BUTTON = forward feed - Push the button once - this activates the rollers and will allow you
to start chipping (if the rotor speed is high enough).
RED BUTTON = stop feed / emergency stop - This button stops the rollers from feeding. It overrides
all other buttons or bars and will not allow the other buttons to function until it has been reset.
To reset, twist until it returns to its original position. The forward and reverse buttons will now function.
BLUE BUTTON = reverse feed - allows you to back material out of the rollers. The rollers will only
turn in reverse as long as you keep pressing the button. You do not have to press the STOP button
before pressing the GREEN FEED button to recommence feeding.
See page 5 for more detailed information.