Timberk THU UL 32 E (BU), Инструкция по эксплуатации

Страница: 12 / 20

IM2020
12
15. Do not put the humidifier in water or other liquids.
16. Do not install the humidifier in the corridor or in other places where it may be hit, knocked over, etc. If
the humidifier is not in use, disconnect it from the power supply.
17.
Do not lay the power cord under carpets or other objects. Position the humidifier so that the cord can’t
be accidentally touched. Make sure that the power cord does not touch sharp edges or hot surfaces.
18. Do not use outdoors or in high humidity areas. Excessive humidity in the room can cause water to
condense on windows and furniture. If this happens, turn off the humidifier.
19. Do not allow foreign objects to enter the humidifier.
20. Do not sit, stand, or place heavy objects on the humidifier.
21. To prevent damage to the humidifier, do not add essential oils, preservatives, flavorings, or other
impurities to the water in humidifier. The manufacturer and seller are not responsible for the damage to
the humidifier in case of ignoring this warning.
NOTE
High-frequency vibrations of the membrane of the ultrasonic humidifier are not audible and are
completely safe for people and pets.
22.
If the device was at a temperature below 0ºC for some time, it must be kept at room temperature for at
least 2 hours before turning it on.
23. Do not use accessories that are not supplied.
3. APPOINTMENT OF THE DEVICE
A humidifier increases relative air humidity in a room and stabilizes its microclimate, allowing to avoid
harmful conditions of low humidity. Comfortable conditions are achieved at relative air humidity of 40 to 60%.
Insufficient air humidity results in dehumidification of mucous membranes which is the cause of decrease in
immunity, head ache, cracking of lips, “sandpaper” in the eyes, also
insufficient air humidity enables
development of infection and causes respiratory illnesses, fatigue, increased eye fatigue and worsening of
concentration, and has negative effect on pets and indoor plants, causes increased dust generation and
electrostatic charging of synthetic fabrics.
4. SPECIFICATIONS
Specifications of the device are shown in Table 1.
Table 1
Parameters Units THU UL 32 E (BU) THU UL 32 E (W)
Capacity of humidity ml/h 300 300
Power supply V/Hz 220~/50 220~/50
Water tank volume L 5 5
Rated power consumption W 25 25
Rated current
А
0.11 0.11
Noise level dB
(А)
34 34
Moisture protection class - IPX0 IPX0
Electrical protection class - Class II Class II
Device dimensions mm 195x195x327 195x195x327
Packing dimensions mm
229х229х359 229х229х359
Net weight kg 1.15 1.4