Timberk T-PAC12-P11E, Инструкция по эксплуатации

Страница: 31 / 64

IM2021
31
Protection function
1 Frost Protection Function:
In cooling, dehumidifying or economic power saving mode, if the temperature of the
exhaust pipe is too low, the machine will automatically enter protection status; if the
temperature of the exhaust pipe rises to a certain temperature, it can automatically
revert to normal operation.
2 Overflow Protection Function:
When water in the water pan exceeds the warning level, the machine will automatically
sound an alarm, and the "FULL" indicator light will flash. At this point, you need to
move the drainage pipe connecting the machine or the water outlet to sewer or other
drainage area to empty the water (details see Drainage Instruction s at the end of this
chapter). After the water is emptied, the machine will automatically return to the original
state.
3 Automatic Defrosting (cooling models have this function): The machine has
automatic defrosting function. Defrosting can be achieved through four - way valve
reversing.
4 Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay booting
protection function after the compressor is turned off.
9. MAINTENANCE
ATTENTION! Disconnect the unit from the mains before cleaning.
Condensate removal instructions
1. When condensate is filling the tank, switch off the air conditioner and turn off the
power.
Note: Move the device carefully to avoid spilling of water in the bottom of the case
2. Place the water container behind the outlet at the rear part of the device
3. Unscrew the drain cap and pull out the plug, the water will automatically flow into the
water tank.
Note:
1. Hold the drain plug cover, and the water plug properly.
2. During drainage, the housing may be tilted slightly backwards.
Note:
If the water container can’t contain all the condensate from the air conditioner,
cover the drain with a plug as soon as possible to prevent water from spilling onto the