Timberk Giant SWH RE5 120V, Инструкция по эксплуатации

Страница: 9 / 28

9
ENGLISH
NOTE !
Position «COMFORT» on the control panel corresponds to optimal
temperature of water heating 58 +/-2 ° , which is characterized
by:
1. Reduction of burn risk in cases, when water temperature at the
outlet is adjusted incorrectly.
2. Sufficient amount of hot water after mixing with cold water,
with lower power consumption.
3. Formation of lower amount of scale on the heating element and
interior surfaces of the water heater.
8. MAINTENANCE
Fig . 6
Fig . 5
1. Check the electric plug and the socket as often as possible. It is
necessary to ensure reliable electrical contact and correct earthing.
The plug and the socket should not heat excessively.
2. If the water heater is not used for a long time, especially in regions
with low air temperature (lower than 0
° ), please, drain water from it
(see clause 6) to avoid its damage (due to freezing of water in the
interior tank).
3. In order to ensure reliable work of the water heater during a long
time, it is recommended to clean the interior tank occasionally and
remove scales on electric heating elements. It is also recommended to
check the condition of magnesium (whether it is decomposed
Drain control
Mail screw
Pressure drop
4. Scheduled maintenance should be performed with strict observation
of the instruction manual and safety arrangements.
5. The water heater is equipped with a thermoswitch, which will stop
power supply of the tubular electric heater in case of water overheating or
if there is no water in the heater. If the water heater is plugged, but water is
not being heated and the indicator lamp is not flashing, it means that the
thermoswitch has turned off of has not been turned on. In order to return
the water heating to working condition, it is necessary to:
- disconnect the water heater and remove the control panel.
- press the button in the center of the thermoswitch until its clicking
position, see Fig.7;
- if the button cannot be pressed and there is no click, then wait until
the thermoswitch cools down to initial temperature.
ATTENTION !
The manufacturer provides an increased warranty for several
components of the water heater subject to timely and correct
performing of periodic maintenance of the appliance by
specialists from an authorized service center (see guarantee slip).
completely or not), in order to replace it timely in case of its complete
decomposition.
Frequency of the tank cleaning depends on hardness of water found in
this territory. Cleaning should be performed by special services. You may
found out an address of the nearest service center from a shop assistant or
at
www.timberk.c m .
ATTENTION !
If these actions have not taken a positive effect or if the
thermoswitch turns off repeatedly within a short time interval,
then it is necessary to disconnect the water heater, turn off the
water supply to the water heater and address an Authorize service
center Timberk in your region for consultation or repair of the
appliance.
www.timberk.com e lectric storage water heater