Timberk Giant SWH RE5 120V, Инструкция по эксплуатации

Страница: 7 / 28

7
ENGLISH
11. Consumer 1
12. Consumer 2
13. Consumer 3
14. Water heater
15. Control panel
16. Thermometer
*-not included in the delivery set
Connection to water main
1. The heater should be connected to the water supply network with the
minimum pressure of 0.1 MPa and maximum pressure of 0.75 MPa
NOTE :
The water heater is an appliance operating in the way that water
pressure in it corresponds to water pressure in the water main. If
pressure in the water main is more than 0.75 MPa, it is necessary to
mount a pressure reducer before it to set the pressure at the level,
which does not exceed 0.75 MPa.
2. The water heater is connected to the water supply system with the
use of pipes with diameter of G1 /2.
3. In order to avoid leakage while connecting the pipes, use rubber
packing on screwed pipe ends.
4. Define an inlet nozzle and outlet nozzle or 2 outlet nozzles (see Fig. 4 )
needed for connection to the water main. After that fasten a packing on
unused nozzle(s).
5. Fasten a safety valve on the inlet nozzle marked with blue colour in the
way that water current corresponds to direction of an arrow on the valve
case.
ATTENTION !
Connect the water heater nozzles only to pipes and fittings de-
signed for temperature exceeding 80
° at maximum working
pressure . It is not recommended to use materials not designed for
high temperatures.
NOTE :
In order to facilitate maintenance of the water heater in case of upper
connection of cold water to the inlet nozzle «I», it is recommended to
install a shutoff valve on the inlet nozzle «II», which will allow
connecting of a drain hose to it, if needed, and discharging of water
from the water heater to sewerage system.
In order to facilitate maintenance of the water heater in case of lateral
connection of cold water to the inlet nozzle «II», it is recommended to
install a T-piece drain cock between the inlet nozzle «II» and the safety
valve, which will allow connecting of a drain hose to it, if needed, and
discharging of water from the water heater to sewerage system.
ATTENTION !
If water in the installation place contains large amount of calcium,
manganese or iron salts, then it is necessary to mount a
corresponding filter in the feeding system to reduce the amount of
scale in the tank and on the heating element.
6. Connect the heater with a mounted valve to the water supply
network and install a shutoff valve at the point of water connection.
7. Connect desired number of consumption points to outlet nozzle(s)
marked with red colour.
8. Turn on the shutoff valve and one of dismountable cocks. When the
tank is filled (that is testified by discharging of water from a
dismountable cock), turn off the dismountable cock and check leak
tightness of all connections.
www.timberk.com e lectric storage water heater