Timberk Giant SWH RE5 120V, Инструкция по эксплуатации

Страница: 8 / 28

8
Connection to electric network
ATTENTION !
Before connection of the storage water heater, make sure that it is
earthed in proper manner. Correct earthing is important for
minimization of electric shocks and ignition risks. Power cord is
equipped with a plug with earth contact. The appliance should be
used with correctly earthed main socket. If the socket that you
plan to use is not earthed in respective manner or protected by a
time-delay fuse or by a circuit breaker, please contact a qualified
electrician to install a correct socket.
1. The water heater is designed for connection to the electric network
with one-phase voltage of 220 V. Before connection, please, make sure
that parameters of the electric network in the place of connection
correspond to parameters shown on the marking plate with the
appliance specifications. During installation of the appliance it is
necessary to observe the effective electrical safety regulations
.
2. The main socket should be designed for rated current of at least 12 A,
electrical cable with the core section of not less than 3x1.5 mm2 (for
copper).
3. The electrical network should be equipped with a breaker assembly
designed for 16 A.
4. The main socket and plug should always be dry in order to avoid
current leakage. Check that the plug is connected to the socket tightly.
Such regular checks should be performed in the following order: insert
the plug in the socket, half-an-hour later switch the water heater on and
unplug it and then check if the plug is hot. If the plug temperature is
more than 50
° , then, in order to avoid damages, incidents, fires as a
result of poor contact, replace the socket. It should be done by a
specialist.
ATTENTION !
In order to ensure reliable performance and safe operation of the
water heater, check correctness of its connection to the 220 V AC
electrical network before it is switched on for the first time. The
connected water heater should be securely connected with an
earth circuit of your electrical network.
7 . WATER HEATER OPERATION
1. First, turn on one of dismountable cocks at the water heater outlet,
then turn on an inlet cock. The electrical water heater will start filling
in with water. When water discharges from the dismountable cock
freely, it means that the water heater is full of water and the
dismountable cock may be turned off.
ATTENTION !
During normal operation the cold water inlet cock should be
turned on.
2. Insert the electric plug in the socket.
ATTENTION !
The socket should be designed for rated current of at least 12 A,
electrical cable with the core section of not less than 3x1.5 mm 2
(for copper).
Move the control panel up and turn a thermostat knob (see Fig. 2)
clockwise and set the desired temperature of water heating. This
temperature may be set within the range from +35
° (±5 º ) («MIN»
position if the thermostat knob) to +75 ° (±5 º ) (extreme right
position of the thermostat knob « » ).
In order to decrease the temperature of water heating, turn the
thermostat knob counterclockwise.
4. The water heater thermostat maintains water temperature
automatically. When temperature of water inside the heater achieves
the set value, heating will be turned off automatically and a lamp of
the control panel will flicker out. Then, water temperature will be
maintained due to heat insulation. When water temperature drops
lower than the set value, the heating will turn on automatically and
the indication lamp will flash on.
5. In order to turn the water heater on, turn the thermostat knob to
extreme left position « » and unplug or disconnect the appliance.
www.timberk.com e lectric storage water heater