Timberk AERO I Series, Инструкция по эксплуатации

Страница: 28 / 36

IM2020
28
ATTENTION!
Frequent triggering of the emergency shutdown device is not normal mode of operation of the
curtain. In case of constant triggering of the thermal limiter, it is necessary to disconnect and
unplug the curtain, find out and eliminate what caused the emergency shutdown device to
trigger.
4. Turning off
Set the operating mode selector knob to the position and let the device run for 3 minutes in
ventilation mode to cool the heating element, then set the operating mode selector knob to
position and disconnect the device from the power supply.
ATTENTION!
In order to increase the life time of the air curtain, it is recommended to follow the above
mentioned instructions for turning off the device. Turning off the curtain without cooling the
heating elements first can cause overheating and premature failure of the heating elements.
THC WS2 3M AERO, THC WS2 5M AERO control panel
Fig. 7*
1. Fan switch
Used to turn on/off the fan motor.
2. Two-button switch for heating power modes
Used to select the following heating power modes: low heating power mode , high heating
power mode .
*The appearance of the control panel may differ from the images in the manual
Operation of THC WS2 3M AERO, THC WS2 5M AERO
1. Turning on
1.1. Before turning on the air curtain, the switch buttons must be in “0” position.
1.2. Connect the air curtain to the power source by plugging the power cord into a power outlet.
1.3. Set the fan switch to position, the indicator in the switch will light up, and the device will
start to work in ventilation mode.