TIL TiL-90-6R, Инструкция по установке и эксплуатации

Страница: 23 / 42

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TLC-100 90-6R Installation & Operating Instructions TiL 92RE130 Rev C
4-5
TABLE 4.2 OPERATORS SWITCHES, CONTROLS AND INDICATORS
(Continued)
SWITCHES
CONTROLS &
INDICATORS
FUNCTIONAL DESCRIPTION
CHAN LABEL Indicates the Frequencies programmed for each channel.
CHANNEL LED's Six GREEN LED numbered 1 through 6 indicate the channel selected by the
Channel Selector Switch.
LOUDSPEAKER An 8-ohm internal speaker reproduces the receiver audio output. The audio line is
disconnected from the internal loudspeaker when the transceiver is operated in Tx
mode or when the SPEAKER/PHONE connector is in use.
SPEAKER/
PHONE
CONNECTOR A 3-pole connector provides interconnection to either an external loudspeaker or
headphone. When in use, the internal speaker is disconnected and the VOLUME
control sets the audio level applied to the external speaker or headphone.
AC SWITCH A single pole switch applies AC power to the Model SPG-010 Power
Supply/Charger.
AC POWER ON
LED INDICATOR A GREED LED indicates when AC power is applied to the SPG-010 and the AC
POWER SWITCH is set to ON. Also indicates that the Model SPG-010 Power
Supply is functioning.
AC FUSE A 2.5 Amp fuse protects the Base Station power supply from internal short circuit
or transceiver short circuit.
EXTERNAL
DC FUSE A 5 Amp fuse protects the external batteries when connected.
External Battery
ON/OFF Switch A toggle switch allows external batteries (when connected) to be switched in or
out of the circuit. Switch should be in the ON position to trickle charge external
batteries when connected. DC Battery power will be automatically selected should
AC power fail. Switch should be in OFF position if external batteries are not
connected or if transceiver is operating with batteries that are deeply discharged
or that have a defective cell.
*TERMINAL blk Terminal Block with DC output and external battery, +/- connections.
*AC POWER
CONNECTOR 3 Prong AC Connector for use with AC Power Cord P/N 927002-1.
**REMOTE
CONNECTOR 9 Pin "D" type connector (Optional) provides signals required for remote
operation. Refer to Table 1-2 for connector details.
*EXTERNAL DC
CONNECTOR Transceiver chassis mounted connector provides for connection to SPG-010,
terminal block. Mating DC power connector provided.
* Denotes items located on rear panel.
** Item not shown, located on side of the transceiver chassis, if ordered.