TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TLC-100 90-6R Installation & Operating Instructions
TiL 92RE130 Rev C
1-3
1.3.2
Local/Remote Operation (Option 2 required)
The Low Cost Base Station can only be operated in the Remote mode if the transceiver is
ordered with a remote 9-pin connector (extra cost option) which is located on the side of the
transceiver chassis.
Base Stations which employs the Model TiL-90-6R transceiver operates in local and remote
modes simultaneously.
1. LOCAL
OPERATION
- In local operation, voice audio, and keying (PTT) functions are routed
from the microphone to the transceiver. Receive audio is routed to the internal loudspeaker.
2. REMOTE
OPERATION
- In Remote operation, transmit audio, keying (PTT), and receive
audio signals and others are available on the 9-pin "D" connector. See Table 1.2 for remote
connector signal details.
NOTE
In the 90-6R, the audio and PTT signals are connected in parallel. This allows the PTT
and TX audio to be functional on the 9-pin connector as well as on the microphone
connector. The RX audio is routed to the internal speaker via the volume control and to
the 9-pin connector at a constant level.
TABLE 1.2
REMOTE CONTROL CONNECTOR SIGNALS
PIN NO
90-6R "9-pin" Connector Signals
2
3
7
9
5
1
6
8
4
Remote TX/RX Audio (100 ohms)
Remote Recorder Signal (150 ohms)
Remote Rx Audio Signal (600 ohms)
+5 Vdc
PTT
Ground
Squelch
RF Indicator
Microphone - TX Audio (220 ohms)
1.3.3
AC and DC Operation
The unit can be operated by external 120 VAC or external 13.7 VDC battery power.
1.
AC OPERATION
- During AC operation, the unit can trickle charge external batteries via
the +/- Battery connections located on the terminal block mounted on the rear of the
SPG-010 Power Supply. The external battery ON/OFF switch must be in the ON position
for these functions to occur when an external battery is connected. A 220Vac version of
the SPG-010 can be specially ordered.
2.
DC OPERATION
- The transceiver unit can be operated from an external DC battery
supply within the range of 11.5 Vdc to 15.0 Vdc. A DC connector is mounted on the rear
of the 90-6R which mates with DC Power Cable P/N 863701-1 (Supplied).
Spade connectors are provided on the other end of this cable to mate with the DC +/-
output connections on the terminal block of the SPG-010. A 12 Volt Battery Back-up Kit
(7.2 AH), P/N 989979-2 is available. See section 3.6 of this document for details.
1.4 TECHNICAL
SUMMARY
A summary of electrical, operational, mechanical and physical characteristics of the Base Station
are provided in Tables 4.1.
Содержание TiL-90-6R
