TIL TiL-90-6R, Инструкция по установке и эксплуатации

Страница: 17 / 42

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TLC-100 90-6R Installation & Operating Instructions TiL 92RE130 Rev C
3-3
3.4 RECEIVER OPERATION
To operate the transceiver in the receive mode, proceed as follows:
(1)
Ensure that the PRESS-TO-TALK switch on the microphone is NOT depressed, and
verify that the Tx ON amber LED is OFF.
(2) Verify that the correct operating frequency is indicated on the front panel. Refer to
Section 4 for Channel/Frequency selection.
(3) Adjust the SQUELCH control to suit local reception conditions. When the SQUELCH
control is rotated in the counter-clockwise direction, the SQUELCH indicator green LED
will switch to ON, indicating that the squelch circuit is connecting the demodulated audio
output to the VOLUME control.
Further adjustment of the SQUELCH control determines the squelch setting.
(4) The VOLUME control can then be adjusted in a clockwise direction to increase the audio
level, or in a counter-clockwise direction to decrease the audio level which can be heard
on the internal loudspeaker.
NOTE
When an external loudspeaker or headset is
connected to the SPEAKER/PHONE jack of the
transceiver, the internal loudspeaker is automatically
disconnected. The VOLUME control will now control
the audio level applied to the external loudspeaker or
headset, as applicable.
(5) Refer to Section 4 for transceiver specific operating modes.
3.5 SWITCHING OFF
To switch off the Low Cost Base Station:
(1)
Set the POWER ON/OFF on transceiver to switch to OFF.
(2) Verify that all indicator LED's on the front panel are OFF.
(3) Set the External Battery ON/OFF switch on the SPG-O10 Power Supply to OFF.
(4) Set the AC ON/OFF Power Switch on the SPG-010 Power Supply/Battery Charger to the
OFF position.