Tiger SIDE ROTARY JD6110-30M/R T4F, Монтаж и эксплуатация

Страница: 38 / 202

ASSEMBLY
Assembly Section 2-8
PRESSURE LINE INSTALLATION
The hydraulic pressure line will be plumbed into the rear of the tractor remote valve. Locate
the pressure port on the rear remotes and remove the plug (refer to the Hydraulic Ports
illustration and the Parts Section pages for position of the pressure port). After the plug is
removed install 27mm adapter. Next, connect a 1/2” hose from the tractor remote valve to the
Tiger valve.
(ASM-27mmPRESSURE-0001)
RETURN LINE INSTALLATION
The return line will be plumbed next to the pressure line on the tractor remote valve. Locate
the return port and remove the plug (refer to the Hydraulic Ports illustration and the Parts Section
for the position of the return port). After the plug is removed install 27mm adapter or elbow.
Next, connect a 1/2” hose from the tractor remote valve to the Tiger valve.
(ASM-27mmRETURN-0001)
LOAD SENSE LINE INSTALLATION
The load sense line will be plumbed into the bottom of the tractor remote valve (refer to the
Hydraulic Ports illustration and the Parts Section pages for the position of the load sense port).
Locate the plug on the tractor rear remotes for the load sense, and remove the plug. Install a
14mm adapter or elbow and run a 1/4” hose from the remotes to the Tiger valve. Refer to the
Parts Section pages for an exploded diagram of the tractor remote valve hookup.
(ASM-14mmLOAD SENSE-0001)
VALVE MOUNTING
The mounting bracket for JD 6xxxR series tractors features two long legs which need
to be attached as shown in the photo below. Secure the bracket to the tractor with
hardware shown in the Parts Section of the manual. Align the holes for the cables on the
Husco control valves and center the Danfoss valve on the valve plate. Then align the
holes on the valve with the plate holes and secure the lift valve on top of the mounting
plate. Route the hydraulic lines from the lift valve to the hydraulic cylinders as noted on
the lift valve page of the Parts Section. Install the control cables to the valve and the
mounting plate on the Husco valves. On the Danfoss valves, attach the electrical control
cables.
(ASM-JD7X30-0001 JD6140R)