Tiger SIDE ROTARY JD6110-30M/R T4F, Монтаж и эксплуатация

Страница: 105 / 202

MAINTENANCE
SIDE ROTARY Maintenance Section 4-15
© 2014 Alamo Group Inc.
MAINTENANCE
GREASING DRAFT BEAM PIVOT POINTS
Locate the grease zerks on the inner and outer draft
beam pivot bosses. Inject Lithium-Complex
extreme pressure grease, conforming to NLGI2-
ISO 320 specifications, into each zerk until grease
protrudes from joints. Gr ease all pivots daily or
every 8 hours of service.
With the cutter head lowered, locate the grease
zerks on the linkage and pivot bosses. Inject
Lithium-Complex extreme pressure grease,
conforming to NLGI2-ISO 320 specifications, until it
protrudes from the ends. With the cutter head in this
position it is also possible to grease the draft beam
cylinder anchors and pins. Now raise the cutter
head to expose the remaining zerks on the deck tilt
linkages and on the other end of the cylinder.
GREASING PUMP DRIVE SHAFT COUPLER
With engine stopped, ensure driveshaft alignment
by grasping coupler and sliding back and forth.
Coupler should slide freely with approximately 1/8”
of end play. If coupler does not slide freely, inspect
for loose pump mount bolts, or damaged or loose
crankshaft adapter. Inject-Lithium Complex extreme
pressure grease, conforming to NLGI2-ISO 320
specifications, into co upler until grease begins to
protrude from ends. Grease daily or every 8 hours.
Do not over grease.