Tiger SIDE ROTARY JD6110-30M/R T4F, Монтаж и эксплуатация

Страница: 101 / 202

MAINTENANCE
SIDE ROTARY Maintenance Section 4-11
© 2014 Alamo Group Inc.
MAINTENANCE
POLYCARBONATE CARE AND MAINTENANCE
The proprietary UV and Abrasion Resistant surface coating on SHIELDS SUPERCOATED polycarbonate
significantly improves performance. Periodic cleaning using proper procedures and compatible cleaners are
recommended to prolong service life. Tiger Corp. polycarbonate is SUPERCOATED on both sides.
CLEANING THE SUPERCOAT HARD-COAT
1. Wash with a mild solution of soap or detergent and lukewarm water.
2. Using a soft cloth or sponge, gently wash the sheet to loosen dirt and grime and rinse well with clean
water.
3. To prevent water spotting, thoroughly dry with chamois or cellulose sponge.
4. Avoid the use of abrasive cleaners, squeegees and/or other cleaning implements that may mar or gouge
the coating.
CLEANING AGENTS WHICH HAVE BEEN FOUND TO BE COMPATIBLE UNDER LABORATORY
CONDITIONS:
• Aqueous Solutions of Soaps and Detergents
Windex
Top Job Joy Mr. Clean
Fantastik Formula 409 Sumalight D12 Brucodecid
• Organic Solvents
Butyl Cellosolve
Kerosene Hexel, F.O. 554 Naphtha (VM&P Grade)
Neleco-Placer Turco 5042
• Alcohols
Methanol
Isopropyl
All residual organic solvents should be removed with a secondary rinse.
GRAFFITI REMOVAL
Butyl cellosolve (for removal or paints, marking pen inks, lipstick, etc.) The use of masking tape, adhesive tape
or link removal tools work well for lifting off old weathered paints.
To remove labels, stickers, etc., the use of kerosene or VM&P na phtha are generally effective. When the
solvent will not penetrate sticker material, apply heat (hair dryer) to soften the adhesive and promote removal.
If a material is found to be incomp atible in a short-term test, it will usually be found to be in compatible in the
field. The converse, however, is not always true. Favorable performance is no guarantee that actual end-use
conditions have been duplicated. Therefore, these results should be used as a g uide only and it is
recommended that the user test the products under actual end-use conditions.