Tiger SABER BOOM JD6145-55M/R T4F, Монтаж и эксплуатация

Страница: 58 / 266

ASSEMBLY
Assembly Section 2-26
RS AXLE BRACE MOUNTING
The rear stow axle braces are to be mounted under the rear axle of the tractor. The other
end of the axle brace mounts on the outside of the lower rear corners of the mainframe. After
attaching the boomrest, it should fit tightly and level under the tractor. Attach the axle brace(s) to
the mainframe with hardware shown in the Parts Section and tighten. Attach the axle braces to
the rear axle using the mounting hardware shown in the Parts Section, but DO NOT tighten.
SABER BOOMREST MOUNTING
Carefully raise the Saber boomrest and align the holes with those of the axle brace. Now
install all attaching hardware, as shown in the Parts Section, loosely, to allow for the alignment
with the left and right axle brace. Tighten / torque all hardware on the brace and the boomrest.
Finally, add the adapter to the boomrest.
(ASM-JDBOOM-0001_6145-55 Saber)
DECK ATTACHMENT
The pivot assembly is used to attach the head to the secondary boom. Install the deck pivot
cylinder using the pins and hardware, which is illustrated in the Common Section.
Connect the fittings and hoses from the pivot cylinder to the small preformed tubes on the
boom arm. Connect the fittings and hoses from the motor to the large preformed tubes on the
boom arm. Connect all remaining hoses from the control valve to the cylinders and / or preformed
tubes on the boom arm. Refer to Common Section for diagrams.
(ASM-C-0018)