Tiger SABER BOOM JD6145-55M/R T4F, Монтаж и эксплуатация

Страница: 46 / 266

ASSEMBLY
Assembly Section 2-14
CABLE CONTROL LEVER STAND
On the corner cab post, mark a point at 1-3/8” from the windshield and 22-1/2” from
the floor; then cut a 3/4” diameter hole through the outer plastic shell. This will expose a
threaded steel boss to attach the control box support bracket.
The rear corner of the cable control stand is
placed approximately 6-1/4” from the edge of the
mat. The front edge of the stand is up against the
corner cab post and the door sill lip of the mat.
Before you mark or drill any holes, check for support
plates or wires under the mat and the cab floor.
NOTE: Cutting into plates or wires makes more
work for everyone and could be dangerous. When
you know where the wires/plates lie, mark one of
the mounting holes. Drill a 3/8” hole through the
mat and through the floor of the cab. Next, lift the
mat up and mark the other two holes on the cab
floor. Drill the holes through the floor. Mark the mat and drill the other two 3/8” holes.
Use a 1” hole saw and cut a 1”
hole through the mat over each
3/8” hole. Secure the stand to
the floor with the spacers,
capscrews and nylock nuts
provided.
Secure cables and wires
from the control stand with zip
ties and route past the right side
of the driver’s seat. Drill a 2 1/4”
diameter hole in the triangular
area behind the driver’s seat.
Drilll a hole to the outside rear of
the tractor.
Wrap the cables with the 6” split hose at the point they pass through the hole, and
secure the zip-ties. Apply RTV sealer in and around individual cables and split hose,
inside and outside of the cab for a water tight seal. Install upper support bracket from cab
post to the control lever stand.
(ASM-JD CBL MNT-0002c)