Tiger M6-131, Монтаж и эксплуатация

Страница: 48 / 226

ASSEMBLY
Assembly Section 2-18
DECK ATTACHMENT
Attach the head to the secondary boom using the pins and hardware shown in the Parts Section
to attach linkages. Install the square tube on the top of the head into the head mount and secure
using the mounting plate and hardware as shown. The mount should be positioned to the left side of
the cutter head. Install the deck pivot cylinder using the pins and hardware also shown in the Parts
Section.
Connect the fittings and hoses from the pivot cylinder to the small preformed tubes on the boom
arm. Connect the fittings and hoses from the motor to the large preformed tubes on the boom arm.
Connect all remaining hoses from the control valve to the cylinders and / or preformed tubes on the
boom arm. Refer to Parts Section for diagrams.
Before proceeding to the final preparation step, double check the complete
assembly from the mainframe to the cutter head against the diagrams in the Parts
Section for proper placement and assembly of all components.
(ASM-C-0060)
BOOM MOUNTING BRACKET
Using a floor jack and / or a hoist, raise the boom mounting bracket up to level and slide the
bracket into position onto mainframe as shown in Parts Section.
Install pin through mainframe and bracket. Secure with capscrew, lockwasher and hex nut
through boss on mainframe as shown.
Secure mounting bracket to mainframe with the capscrews, lockwashers, flatwashers, cut
flatwashers and hex nuts provided. Secure using the two slotted holes on the bracket and
mainframe.
(ASM-C-0014)
SWIVEL BRACKET MOUNTING
Install the boom swivel bracket onto the mainframe with the swivel pin. Secure the pin in
place using the capscrews, etc. through the hole in the boss and pin. NOTE: The head of the
capscrew must be toward the front of the tractor.
Install all new swivels and fittings on the swing cylinder with swivel openings facing each
other. Fittings will vary in type and direction depending on your application; refer to the Parts
Section for more details.
Install bearings in the mainframe anchor for the swing cylinder. This may have already been
done for you.
Install the swing cylinder between the boom mounting bracket cylinder anchor and the boom
swivel with the pins. Insert roll pins through the top and the bottom hole in the pins.
Attach hoses from the control valve to the swing cylinder.
(ASM-C-0015)