Tiger M6-131, Монтаж и эксплуатация

Страница: 36 / 226

ASSEMBLY
Assembly Section 2-6
MAINFRAME INSTALLATION
With an overhead hoist and / or jack-stands, raise one side of the frame up to the correctly
matching mounting holes. Install capscrews and other hardware to secure the sides of the
mainframe to the tractor casting, as shown on the tractor mount kit page in the Parts Section.
DO NOT tighten at this time. Remove the capscrews one at a time and apply a thread locking
agent. Reinsert the capscrews and tighten / torque to values noted in the torque chart located in
the Maintenance Section of this manual.
(ASM-C-0003)
CONTINUOUS DUTY SOLENOID SWITCH
Mount the solenoid switch, drill holes to match if necessary, in a dry and well protected area.
Secure as shown in the Parts Section with provided 3/8” x 1” capscrews, lockwashers, and hex nuts.
Route wires to and from the Continuous Duty Solenoid Switch as shown below.
A.) ORANGE 10 GA. wire from terminal (A) to +12V battery fusible link.
B.) RED 14 GA. wire from terminal (C) to tractor plug in cab.
C.) BLACK 14 GA. wire from terminal (B) to -12V battery post.
D.) RED 10 GA. wire from terminal (D) to switch box.
E.) RED 14 GA. wire from terminal (D) to temperature gauge. (optional).
(ASM-NH-0032)