Tiger M6-131, Монтаж и эксплуатация

Страница: 38 / 226

ASSEMBLY
Assembly Section 2-8
SWITCHBOX WIRING
Power for the switchbox is accessed through the auxiliary plug located on the right rear of the
cab. A John Deere plug is used, part number RE67651. DO NOT connect the plug to the cab
port until the wiring is completed. The wires in the plug are colored RED, BLACK and ORANGE.
Either the RED or ORANGE wire will always be hot, so it needs to be capped. Attach connector
34538 to end of the wire and tape wire back on itself. The other wires are hot when tractor key is
turned to “on”. Connect the BLACK wire of the plug to the BLACK wire from the switch box.
Then connect the other “Keyed Hot” wire of the plug to the RED wire from the switchbox.
The two GREEN wires from the switch box must be connected to the neutral safety wire by
cutting the neutral safety wire and connecting one GREEN wire to one end and the other GREEN
wire to the other. The neutral safety wire is the black wire with the white stripe.
Use a test light
or meter verify this wire is the neutral safety wire. When testing for the neutral safety wire, the
correct wire will only be hot when the ignition is in the start position. Cut the neutral wire and
connect the green wires from the switchbox as shown in the wiring diagram.
Route the cables and wires from the switchbox along the right console back to the plug under
the rear window. Cover the wires with wire wrap, cut a small cross hair pattern into the plug and
route the wires through the hole. Attach the wires to the console with the push mounts. Mark
where you want to route the cable. To avoid hitting any existing components, remove the
console so you can see where you are drilling. Drill three 1/4” holes in the console for the push
mounts and replace the console. Thread a zip tie through the push mounts and push the mounts
into the 1/4” holes. Do not snug the zip ties until all the wiring is complete. From the rear of the
tractor, run the white wire to the solenoid valve. The travel lock orange wires from the switchbox
should also be covered with wire wrap and will be run with the white wire. These wires will be
connected to the electronic travel locks located on the lift valve.
(ASM-KUB-0035)