Tiger JD5085-5115M T4F, Монтаж и эксплуатация

Страница: 41 / 194

ASSEMBLY
Assembly Section 2-9
SWITCHBOX WIRING
Route the wires from the switchbox to the front console panel. Refer to the
Parts Section for wiring diagram to hook up the switchbox. Cover the wires from the
switchbox with plastic wire wrap provided. Remove the console panel under the
steering wheel to access wires. Locate the neutral safety brown colored wire.
Use
a test light or meter to verify this wire is the neutral safety wire. There are three
brown wires. Cut the brown neutral safety wire and connect the green wires from the
switchbox as shown in the wiring diagram.
Run the white and black wire to the solenoid valve. Route the wires through the
back window with the cable control wires. Use the rubber grommet in the window to
protect the wire, and route the wire out of the cab down to the 1/4” hydraulic hoses.
Follow the hydraulic hoses through the wheel well to the front of the tractor.
Route the red 14ga wire, keyed hot, from the auxillary plug to the signal post of
the continuous duty solenoid. NOTE: Be certain that the power taken for the
switchbox is “HOT” only when the tractor ignition is “ON”.
The black wire from the switchbox should be routed to the auxilary plug.
The wires from the switchbox are longer than needed and should carefully cut and
spliced as required. Zip ties should be used to secure the wires to the tractor framework
and hoses to eliminate vibation and rubbing.
(ASM-JD-0055)