Tiger JD5085-5115M T4F, Монтаж и эксплуатация

Страница: 129 / 194

MAINTENANCE
TRIPLE FLAIL Maintenance Section 4-27
©2016 Alamo Group Inc.
MAINTENANCE
STANDARD OR HEAVY DUTY SIDE OR REAR FLAIL KNIFE
REPLACEMENT
1. If knives are damaged or badly worn, they will need to be replaced as a set. Replacing a single knife can
cause severe vibration and possible damage to the mower.
2. Assemble knives, clevis, bolts and nuts as shown in parts manual.
3. Install locking hex nut so that the flat face of nut is towards the knife.
4. Apply loctite “271” or equivalent to threads.
5. Torque nut to 52 FT. LBS. Knife must swing freely.
DO NOT re-use the locking hex nuts for mounting the knives. If hex nut become loose, or
require removal for knife replacement or any other reason, they must be discarded and
replaced with new nuts.
Knives should not be welded on for any reason.
RECOMMENDED FILLING INSTRUCTIONS FOR REAR FLAIL GEARBOX
When filling or checking the fluid level, the unit
should be parked on a level surface with rear flail
down on surface, shut
“OFF” , and cold, (at ambient
temperature).
Remove the fluid level plug located on the side of
the gear box. The gear box should be filled to the
bottom of the fluid level hole. If necessary, use 75-
90 wt. PAO Synthetic Extreme Pressure Gear Lube
to raise level to bottom of the hole.
Do not over-fill. Excessive gear oil will run back
out of the hole. Reinstall fluid level plug into
gearbox. If gearbox has been over-filled, the excess
may be expelled through the pressurized breather.