Tiger 06090005, Перечень компонентов с инструкциями по монтажу и эксплуатации

Страница: 40 / 68

MAINTENANCE
© 2020 Alamo Group Inc.
MAINTENANCE
Weedoo Sickle Bar Mower Maintenance Section 4-2
Tiger Mowers are designed for high performance and rugged durability, yet with simplified maintenance. The
purpose of this section of the manual is to help the operator in the regular servicing of the mower. Regular
maintenance at the intervals mentioned will result in the maximum efficiency and long life of the Tiger Mower.
When you purchase a Tiger Mower you also acquire another valuable asset, Tiger’s parts organization. Our
rapid and efficient service has guaranteed the customer satisfaction for many years. Tiger parts keep up with
the demands for efficiency, safety and endurance expected of the Tiger Mower.
MAINTENANCE PRECAUTIONS
· Be sure end of grease gun and zerks are clean before using. Debris injected into bearings, etc. with grease
will cause immediate damage.
· DO NOT use a power grease gun to lubricate bearings. These require very small and exact amounts of
lubrication. Refer to the detailed Maintenance Section for specific lubrication instructions. DO NOT over-
grease bearings.
· Be alert to maintenance indicators such as the in-tank filter pressure gauge, hydraulic reservoir sight gauge,
etc. Take the required action to correct any problems immediately.
· Release of energy from pressurized systems may cause inadvertent actuation of cylinders, or sudden release
of compressed springs. Before disconnecting any hoses relieve pressure by shutting tractor off, setting cutter
on ground and actuating lift valve handles.
DO NOT use hands to check for suspected leaks in hydraulic hoses! Hydraulic fluid
escaping under pressure can have sufficient force to penetrate skin and cause serious
injury. If fluid is injected into skin, it must be surgically removed within a few hours or
gangrene may result. Use a small piece of wood or cardboard, not hands, to search for
pin hose leaks. Be sure all pressure is relieved whenever disconnecting lines. Be sure all
connections are tight and hoses and lines are not damaged before applying pressure.
BREAK IN PERIOD
In addition to following the break in instructions for your particular boat, the in-line hydraulic fluid filter should be
replaced after the first 50 hours of service. Thereafter the filter should be replaced every 500 hours, or yearly,
which ever comes first.
WARNING!