Tiger 06090005, Перечень компонентов с инструкциями по монтажу и эксплуатации

Страница: 14 / 68

SAFETY
12/10 Safety Section 1-8
© 2010 Alamo Group Inc.
SAFETY
Maintenance and Service Safety Instructions and Practices
Do not modify or alter this Implement. Do not permit anyone to modify or alter this
Implement, any of its components or any Implement function.
(SG-8)
Never work under the Implement, the framework, or any lifted component unless the
Implement is securely supported or blocked up to prevent sudden or inadvertent falling
which could cause serious injury or even death.
(SG-14W)
Never attempt to lubricate, adjust, or remove material from the Implement while the boat is
in motion or while the engine is running.
(SG-20W)
Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins
are
secured with roll pins or capscrews with nylock nuts
. Serious injury may
occur from not maintaining this machine in good working order.
(SG-21W)
Do Not fill fuel tank while engine is running. Refuel only after engine has cooled down. If
fuel is spilled, move machine away from the area of the spill and avoid creating any source
of ignition until the gasoline has evaporated.
(SG-28)
Use extreme caution when getting onto the boat or Implement to perform repairs,
maintenance and when removing accumulated material. Secure the boat to the dock or
remove it from the water before conducting any service and maintenance on the boat or
implement. Only stand on solid flat surfaces to ensure good footing. Use a ladder or raised
stand to access high spots which cannot be reached from ground level. Slipping and falling
can cause serious injury or death.
(SG-33W)
Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and
hose connections. Relieve hydraulic pressure before performing maintenance or repairs.
Use gloves and eye protection when servicing hot components. Contact with a hot surface
or fluid can cause serious injury from burns or scalding.
(SG-34)
Perform service, repairs and lubrication according to the maintenance section. Ensure the
unit is properly lubricated as specified in the lubrication schedule and all bolts and nuts are
properly torqued. Failure to properly service, repair and maintain this Implement in good
operating condition could cause component failure and possible serious injury or even
death.
(SG-35)