Tiger Serve Assembly Guide
Post Installation Maintenance:
17
2.
Take the filter off by hand and wash it under running water, then leave it to dry.
3.
When the filter is completely dry, fit it inside the bezel by snapping its magnetic
strips to the inside frame of the bezel.
4.
Install the bezel (see steps on page 9).
Installing and Uninstalling the Server Nodes
Usually Tiger Serve is shipped to you with both server nodes pre-installed in the
chassis. The steps below will guide you in case you need to replace a failed server node
or install a new server node to allow for Tiger Serve’s failover capability.
There’s no need to shut down an operating server node, when installing the other
server node in the free drawer. There’s no need to uninstall the appliance from the
rack, in order to install or uninstall a server node.
Warning:
Before proceeding, make sure that the power cord of the server
node you are installing/uninstalling is disconnected from the power source!
Important:
To prevent electrostatic discharge (ESD), touch grounded metal
before touching any of the appliance components. You can also prevent
electrostatic discharge (ESD), by touching the appliance enclosure with the
other hand.
