Tige 2015 ASR, Руководство пользователя

Страница: 93 / 111

Storage Preparation
While the boat is still in the water:
1. Fill fuel tank and add the proper amount of fuel stabilizer
and conditioner according to the engine manufacturer’s
recommendations.
2. Operate boat for at least 15 minutes to be sure the
treated fuel has reached the engine.
When the boat is removed from the water:
Flush the engine cooling system with clean fresh water. DO
NOT exceed 1500 RPM when flushing.
Drain the ballast tank system
CARE & MAINTENANCE
SECTION 6
6-23
IMPORTANT
It is extremely important to drain ballast system during
freezing temperatures and during long periods of non-
use. Protect our natural resources by using environmentally
friendly products and always discard in an environmentally
friendly manner.
1. Drain the system completely after your boat is out of the
water and keep the intake/drain valves open.
2. Use a 50/50 mixture of an environmentally friendly
antifreeze and fresh water.
3. Pour an even amount, approximately 1 gallon (3,8 liters)
of the antifreeze mixture into each tank’s vent.
4. Make sure you catch any spilled mixture by placing a
container under the intake/drain of the tank you are winterizing.
5. Operate the pump in the drain mode for two seconds;
then shut off. Repeat procedure for other tank(s).
6. Close the water intake/drain valves in the ballast tank(s).
When returning your boat back to service, make sure to
drain the remainder of the mixture before getting onto
the water.
6-24