TierTime UP BOX+, Руководство пользователя

Страница: 39 / 47

1
39
Printing Techniques
Air Flow
Adjustment Knob
3. The airflow on print head is adjustable
turn the air flow adjustment knob to change
the amount of cooling of printed object.
Generally the more cooling provided, the
better the print quality. Cooling also help
separate from support and raft. However
cooling also encourage wrapping, especially
for ABS.
To generalize, PLA can take strong cooling
without problem, while ABS should avoid
cooling or give little cooling.
For ABS+ medium cooling is recommended.
Increased cooling will also improve print quality
of fine and overhang structures. Here are
some examples.
1. Ensure accurate nozzle height.
If the nozzle height value is too low, it will cause warping; if it is too high, it will crash the
nozzle into the platform, causing damage and clogging. You can manually fine-tune the
nozzle height value in the "Calibration" section. Try to adjust the nozzle height value plus or
minus 0.1 –0.2mm from the base on previous results.
2. Level platform well.
An unleveled platform usually causes warping. Allow enough time for sufficient pre-heating.
Please use the pre-heat function in the under the Print section. A well preheated platform is
essential for printing large objects without warping.
Fan duct fully opened
Fan duct closed
4. Printing with no raft
It is highly recommended to use raft for normal printing as it improves adhesion and
is required for leveling compensation. It is turned on by default, but you can turn it off
in the "Print Preference" panel.
5. Printing with no support
It is possible to print without supporting structures. You can turn off support by
choosing "No Support" in the "Print Preference" panel. However support will still be
generate up to 10mm to provide a stable base.
Fine structures Overhang Bridging