TierTime UP BOX+, Руководство пользователя

Страница: 13 / 47

1
13
Manual Platform Leveling
Usually users do not need to adjust the
platform manually. This is only necessary if
the automatic leveling function was unable
to effectively level the platform.
There are four screws under the platform
of UP BOX+: two knobs in the front and
two knobs under the platform at the back.
These knobs can be fastened or loosened
to adjust the leveling of the platform.
In the calibration section use the reset button to
set all the compsenation values to zero. Then use
the nine numbered buttons to move the platform to
different locations.
You can also use the "Move" button to move the
print platform to a particular height.
First move the print head to the center of the
platform and move the platform to almost touching
the nozzle (e.g. nozzle height). Use the Calibration
Card to determine the correct platform height.
Try to move the Calibration Card and feel the drag
between the platform and the nozzle. Make sure
you can feel the similar drag resistance at all 9
positions by moving the print head and adjusting
the screws while the platform height is fixed.
The platform is too high.
The nozzle is pinning the
Calibration Card onto the
platform. Lower the platform
slightly.
The height is just right.
Can feel some resistance
when moving paper.
The platform is too low.
No resistance is felt at all
when moving the paper.
Raise the platform slightly.