
COMMANDER
DETAILED
CONFIGURATION
©
Tieline Technology
- 31 -
August 2002
Sub Menus of 07 – Advanced Setup
01 Control mode
Local
Gain of both input channels is set by the two front panel controls on
the “local” COMMANDER.
Master
A pair of Tieline Codecs can be set up to allow the “master” to
control the input gain of the “slave.” The remote Tieline Codec has
the volume mode set to “slave.” Adjusting the Input controls on the
“master” varies the “slave” input gain.
See page 35 for more details.
Slave
Set the remote unit to “slave” for control by the “master”
COMMANDER. Front panel controls are disabled.
Toolbox
Input gain can be adjusted using the Toolbox application. “Toolbox”
mode can be selected on the COMMANDER or by clicking on the
“Setup for T-box” button in the application. Front panel controls are
disabled.
02 Serial Port
Toolbox
Configures the serial port for use with a Computer using the
Toolbox
software.
Data
Use for low speed (< 200bps) data applications such as remote
control or intercom using a TTY terminal.
Disable
Disables the serial port for use with the Toolbox application.
03 Operation
Mode
1
POTS
Use this mode to connect via a standard (POTS) telephone line.
2 Leased
Line
Mode
For operation over leased 2 wire bi-directional lines. As the
COMMANDER modem requires a loop voltage source for correct
operation, an optional line interface unit is available for use with
dedicated 2 wire circuits where the loop voltage is not present.
3 Telephone
Mode
Use COMMANDER as an Emergency phone; You will need to plug
headphones into the headphone socket and a microphone into the
Mic/Line in socket. Dial the phone number on the keypad and when
finished press the
Enter/Dial
key. To finish the call, press the
Hang Up
key.
4 ISDN Mode Use this mode to connect via an ISDN line.
5 Cell Phone
Mode
Use to connect a hands free cable from a mobile phone to the cell
phone socket. Dial the remote TIELINE Codec using the mobile
keypad.
Note: Line quality using Cell Phone Mode is limited to 3Khz, the
mobile networks data rate.
04 Sync Mode
Reserved for future use
(see
www.tieline.com
for the latest software updates)
05 Port Mode
Quick Fn
Settings for the control port on the DB9 connector. Enables the
CMOS Port to be remotely activated by a Quick Function.
Auto
CMOS Port is activated when a link is established.
06 Function Setup
Select F1 or
F2 followed
by 0 ~9
Select desired function from scroll list. Function will be allocated to
combination of F key and keypad digit. See “Function Key Options”
(page 18).