56
Resetting the Type 2 access point
You might need to reset the access point to a known state in order to
add it to the network.
1.
With the power adapter connected, insert the end of a ball-point
pen or paper clip though the small hole on the side of the access
point labeled
Reset
, and gently press and hold the reset button
inside the unit.
2.
Hold the reset button until the Activity LED stops blinking and the
Link LED goes off.
Resetting the Type 1 access point
You might need to reset the access point to a known state in order to
add it to the network.
1.
Position the access point so that the front side faces you, with the
row of five LEDs in the lower-right corner.
2.
Disconnect the Ethernet crossover cable and the power adapter.
3.
While pressing in the switch labeled S1, connect the power adapter
to the access point.
4.
Continue pressing S1 until both the 2nd and 4th LEDs blink
simultaneously (approximately 30 seconds).
5.
Release S1 and wait until the three rightmost LEDs blink
simultaneously (approximately three minutes).
6.
Unplug the power adapter from the power jack on the access point.
Reset
button
InstallationGuide.book Page 56 Wednesday, May 3, 2006 10:19 AM
