Thyracont VD10, Руководство по эксплуатации

Страница: 34 / 48

34
vd10s8-de-131129
4 Operation
4.1 Startup
First connect the required transducers to the corresponding signal inputs 0-10V
or RS485.
The control lines of the relay outputs or are to be wired according to the
particular requirements.
At last the mains cable has to be connected.
When switched-on the VD10 performs a self-test and displays the software
version.
Afterwards the VD10 scans for connected vacuum transducers
while the display shows "scan".
Connected transducers are only detected during this start proce-
dure!
Now the VD10 is operating in display mode / Menu PRESSURE.
If the controller is configured to start mode "run" (start active "on") –as described
in chapter 4.5- the VD10 actuates the relay switches simultaneously with the
display of actual pressure.
Description of keys:
Menu-selection (switch to the next menu)
Start/Stop-function for controlling (s. chapter 4.2)
Confirmation of adjusted values and change to the next input position
(flashing inversely)
Increment input value
Decrement input value
Function key F1
Function key F2
set
F1
F2