THUNDER TIGER Agusta A109, Инструкция по сборке

Страница: 11 / 16

19. Place the wood mount and join the main plate, next
center the wood mount then make marks on fuselage.
20. Remove the wood mount, then use file to make two
notches so the wood rails can fit in later.
21. Install the muffler and check if muffler contacts the
wood mount. You may need to trim the wood mount.
(photos shown is OS91 with
) The
kits comes with muffler extension that you may use.
Check if the throttle lever contacts the muffler if you
use the extension. Trim the contact area if necessary.
Zimmermn muffler
22. CA the main plate and wood mount in place and
make sure the holes on main plate are aimed to the
holes on wood mount.
23. Temporally secure the helicopter on wood mount
with a M3 socket screw, this is to keep helicopter and
wood mount together for next assembly step.
24. Replace the post from the old one. Next install the
body retainer with 3x8mm socket screw and washer.
Adjust the body retainer so it just contact the fuselage.
Make marks at the holes. Do the same procedure at the
other side.
25. Make sure the helicopter and retract are well
positioned. Carefully remove the socket screw, next
use the hole as drilling guide then drill a pilot hole.
Next enlarge the hole to 3mm.
26. Temporally secure the wood mount at the hole you
drew in the last step. Next using the four holes on main
plate as drilling guide then drill pilot holes. Enlarge the
hole to 3mm.
27. Drill 3mm holes at the marks, secure the retainer
with 3x10mm socket screw with M3 washers and
locknut. Secure the wood mount and main plate with
two
3x25mm Socket Screw, POM washer and M3 nut at
far-most two holes.
28. Locate foot step accessories then use care to
install the foot step support on the fuselage, make sure
they are level with each other. Press the retaining
collar firmly then apply CA at the last.
29. Locate the tail boom foam retainer, measure at
18cm(7") from the boom end. Secure foam retainer in
place with CA.
30. Before you install the helicopter into fuselage, get
an extension wire for retract servo. Carefully install the
helicopter in the fuselage, pull the tail boom and
position the helicopter in place properly. Secure the
helicopter with 3x35mm socket screw, POM washer
and M3 Locknut.
11 10