Thunder Scientific 5A-1MP, Руководство по эксплуатации и техническому обслуживанию владельца

Страница: 20 / 96

3 - 9
The factory default printer options are set at and broken down as follows:
0 3 6 0
A B C C
A = 0 for a carriage return only at the end of each line (factory default).
1 for a line feed only.
2 for a carriage return then line feed.
3 for a line feed then carriage return.
B = 0 for no header and no formfeeds.
1 for header, but no formfeeds.
2 for formfeeds, but no header.
3 for header and formfeeds (factory default).
CC = 00-99 lines per page. (factory default=60).
To change the printer options, first determine the appropriate 4 digit number ABCC from the
previous descriptions, then enter the number by pressing
PRT OPT
SET
A B C C
ENTER
If the printer was enabled, or if the
PRINT
NOW
key had been used prior to setting the printer
options, the printer may need to be disabled then re-enabled to make the new printer options
become valid (primarily when changing the lines per page). The options entered remain
valid until changed again or a cold reset is performed. (Refer to Section 3.2.1, Power-Up).
Printer options may also be set from either the RS-232 or IEEE 488 interface. (Refer to
FORM feed, HEAD er, ENDL ine, and LINE s commands, Section 7). Current printer
options may also be stored as power-up defaults through the use of the SAVE command,
Section 7.
3.2.15 Switching Between °C and °F
The 5A-1MP powers up in °F mode. To switch to °C, press the
C / F
key. The
rightmost dot on the lower LED display will illuminate. Return to °F with the same key.
This key affects the display and printer temperature scales only, and does not affect the
temperature scale of the serial and IEEE 488 interfaces which are always °C. The
temperature scale is also selectable through either the RS-232 or IEEE 488 interface. (Refer
to
DEGR ees command, Section 7).