THUNDER LASER
NOVA-51
www.thunderlaser.com
DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
No.197, Hudong Road, Shatian Town,
Tel :(86)769 826653
Dongguan, Guangdong, China
57
4.9 Rotary axis Attachment
The rotary axis attachment option in the printer driver is used in combination of the rotary
axis attachment, to engrave cylindrical objects. To compensate for the different diameters
of different objects, the image must be adjusted. This is performed automatically by the
engraving driver, by selecting the rotary axis option and entering the diameter of the object
to be engraved.
The Rotary size:
To install and set-up the rotary axis attachment proceed as described as follows:
1. Move the working table to the lower position switch off the laser and open the top lid.
2. Put the rotary axis attachment onto the working table and align the rotary attachment
with the x-axis are parallel, with the jaw chuck closest to where the rotary attachment
plugs in and is switched on / off
3. Connect the rotary axis attachment via the control cable with the connector of the
motion system. The connector is located inside the right front of the laser.
Connected
it to this interface and fixed,
then turn on the switch (- is on) and reset the rotary device
by press the
“reset” button on the display (1 is on, 0 is off)
, and then you have finished
the device connection. Like below: