USERS MANUAL MINI 60
D ONGGUAN T HUNDER L ASER E QUIPMENT C O.,LTD
S hatian To wn, S h atian Da dao, M intian
Tel :(86)769 826653
Do ngguan C i ty, G uangdong P r ovince, China
31
stay with the laser.
If laser machine is not at work, the signal lamp is in green light. The green light indicates
the safety situation and the laser machine is ready for operation.
If temperature is higher than 55°C/131°F on working table, the signal lamp will make
buzzing sound. (roughly 80dBA within 1m,75dBA within 5m and 65dBA within 10m,the
sound gets weaker as it travels).
16. Right side up door
Maintenance for the Emergency stop button if required. This door is locked by using outside
locks.
17. Right side door
There are laser controller, driver(Hybrid Servo Drive and Micro Stepper Drive ), TL-Timer
board, the main connecting cables and cooling fan here, please open this door for checking
these parts, but must pay attention to the electric current. if you need to repair, please
contact with professional maintenance staff.
18. Laser switch
The laser power will be on while you turn it on.
19. PC connection port(USB)
This USB is for connecting computer.
20. U-disk connection port(USB)
You can save the file as a U-disk File by press “SaveToUFile” on the software, then save it
to the u-disk and insert the u-disk to the port of laser machine, then use the control panel
to select and control it to work.
21. Ethernet port
This Ethernet port is for connecting computer.
22. Main power switch
The laser machine will be start while you turn it on.
23. LED lamp
It’s used for lighting the working table once turn the Main switch on.
24. Laser supply socket
To connect the main power and the extend power according the label information.
25. Laser tube cover
There are installed the laser tube, red dot pointer device, beam combiner and the first
reflective mirror mount. This door is installed with the flap protection sensor
26. Exhaust hose
This is for installing the exhaust device.
