14
Chapter 4
Operation
When the stage was associated with the driver, various default settings applicable to
the PRM1-Z7 stage were loaded. These settings can now be tailored to your
particular application.
13) Click each tab in turn, and make parameter changes as necessary. If in doubt, run
your application with the default settings unchanged until performance data is
available.
14) After the parameter changes have been performed, click the ‘Persist Settings to
Hardware’ box on each tab, then click ‘OK’. This will ensure that the same
parameter settings will be loaded next time the unit is powered up - even in the
absence of a PC.
15) On the GUI panel, click the ‘HOME” button to move the stage to its home position.
This will establish a zero datum from which future moves can be measured.
