© 2019 Thorlabs
15
PM101x
3.2.15 NTC Input
To monitor the temperature in a test environment, the PM101 has an NTC Input (DA-15 Pin 14)
which allows connection of an NTC thermistor. The measurement range is 0.1 – 100 k
W
. The
set range R0 and the bandwidth B for the NTC thermistor can be adjusted in the OPM software
or through SCPI commands. The default settings are 10 k
W
and 3988 K to directly access the
temperature probe. The measurement range with the PM101 is then -10 °C to 80 °
C with the TSP-TH.
Note
Connection of the NTC to the DE-9 Pin 7 of the Sensor Connector requires a resistance of 0.2
k
W
to 40 k
W
.
3.2.16 Power Supply
All PM101x models use the USB port for power supply. Please provide an appropriate connec-
tion to a PC or power bank.
Note
When operating the PM101 via the RS232 interface or completely autonomously via an analog
output, the unit can either be powered with 5 V via the USB connector or with any supply in the
range from +5 V to +36 V via the DA-15 connector (Pin 1 and Pin 9 (GND)). As an external
power supply, we recommend the
3.3 Software
The PM101x is operated remotely from a PC, laptop or tablet.
Thorlabs OPM Software
The Thorlabs
(OPM) software provides a Graphical User Interface to
view, log, and analyze measurement data. Download the OPM software package from the
Thorlabs website, via this
, through the software tab on the product website, or through
searching for the product name within the Thorlabs
All information on software installation, device control and data management software can be
found in the software manual directly downloaded
.
Note
Do not connect the PM101x prior to software installation!
Attention
Exit all running applications on your PC as the installer may require a reboot of your PC during
installation!
Custom Made Software
The PM101x can also be run using custom made software. For this, please refer to the docu-
ment Write-Your-Own-Application (WYOA) for PM101x.
15