MTS25-Z8 and MTS50-Z8 DC Motorized Translation Stages
Page 4
19593-D02
Caution
The moving platform features a locking screw for the anti-backlash nut inside
the stage. This locking screw, highlighted in Fig 3.1, is set during assembly at
the factory and must not be removed or adjusted. Tampering with this screw
will invalidate the warranty.
Caution
The stages are set up and calibrated at the factory and no further adjustment is
necessary.
Do not allow screws or other objects to protrude through the top platform as this
could damage the internal mechanism.
When mounting components, or fitting the stage within an application, do not
apply excessive pressure to the moving platform as this may damage the
bearing mechanism.
3.2 Mounting
3.2.1 Invalidation of Warranty
Locking Screw for
Anti-backlash Nut
DO NOT TAMPER
Fig. 3.1 Anti-backlash Nut Locking Screw
3.2.2 General
The MTS series stages can be mounted horizontally or vertically using the base
plates, spacer plates and angle brackets previously mentioned - see Section 1.1.
When mounting the stage close to other equipment, ensure that the travel of the
moving platform is not obstructed. If equipment mounted on the moving platform is
driven against a solid object, damage to the internal mechanism could occur.
The range of travel is: MTS25 stages: 25 mm, MTS50 stages: 50 mm
