ELL9K Four-Position Slider Evaluation Kit
Chapter 5: Troubleshooting and FAQ
Rev. C, Feb 2020
Page 15
3. Using a screwdriver or other suitable tool, push down the crimp of each pin to make connection with the ribbon cable.
4. If other connectors are required they should be fitted at this point. Slide each connector onto the cable, paying attention
to the orientation as shown below, then crimp as detailed in step (3).
5.
Fit the terminating connector which will mate with the interface board, taking care to align the cable red wire with
pin 1 as detailed in step (2).
Содержание ELL9
Страница 22: ...www thorlabs com ...
