Thor Fiber 2018 Tel: (800) 521-8467 Email: [email protected] http://www.thorbroadcast.com
3.2 General Setting
Switch on the device and after a few seconds of initialization, it will show start-up pictures as below:
HD IRD
: Device’s name
Bitrate: xx.xxx MHz
indicates the current effective bitrate multiplexed output.
Press LOCK key on the front panel to enter the main menu. The LCD will display the following pages
where user can configure the parameters for the device:
User can do all the settings according to the 8 directions displayed on the LCD. User can press
UP/DOWN buttons to specify menu item, and then press ENTER to enter the submenus as below:
3.2.1 Status
Alarm:
The alarm indicator will turn on if there is no A/V signals inputting or outputting bit rate
overflows. User then can enter this menu to check the error type. Otherwise it shows the ‘system is
normal’.
Uptime:
It displays the working time duration of the device. It times upon power on.
Start up…
Start OK…
HD IRD
Bitrate: xx.xxx Mbps
Main menu
1 Status
2 Input Sets
3 CI Card
4 BISS Descramble
5 TS Config
6 Decoder
7 IP Stream
8 Network
9 System
Alarm
System is normal
Uptime
1 Day(s) 03:30:02
