Attaching
the
Fan
Blades
1.
Attach the blade to blade bracket
using the three screws as shown in figure
14. Start a screw into the bracket. Repeat
for the two remaining screws.
2.
Tighten each screw securely.
3.
Fasten the blade assembly to the
motor by inserting the alignment post
into the slot on the bottom of the motor
and tightening the blade bracket screws.
Please note that the blade bracket screws
are pre-installed into the blade bracket.
(Figure 15).
4.
Repeat steps 1, 2 & 3 for the
remaining blades.
Blade Balancing
All blades are grouped by weight.
Because natural woods vary in density,
the fan may wobble even though the
blades
are
weight
matched.
The
following procedure should correct most
fan wobble. Check after each step.
1.
Check that all blade and blade
bracket screws are secure. Most fan
wobble problems are caused when blade
levels are unequal. Check this level by
selecting a point on the ceiling above the
tip of one of the blades. Measure from a
point on the center of each blade to the
point on the ceiling. Measure this
distance as shown in Figure 16. Rotate
the fan until the next blade is positioned
for measurement. Repeat for each blade.
Measurements deviation should be
within 1/8". Run the fan for 10 minutes.
2. Use the enclosed Blade Balancing
Kit if the blade wobble is still noticeable.
Installing the Light Kit
/ Glass Shade
REMEMBER
to disconnect the power.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE LIGHT KIT
AND THE GLASS SHADE.
1. Loosen the two screws on the
opposite side of four mounting screws
on the bottom of the switch cup ;
remove the other two screws (Figure
17a).
9.
