THM Carbones Clavicula SE, Инструкция, Страница: 23 / 40

LOREM
T H M C L A V I C U L A S E 23
INSTALL
Installing the crankset
Before installing the crankset please check if the bottom bracket is correctly installed and runs
smoothly. For T47, Pressfit 30 and 386 EVO please check if the sealing is mounted. This description
is only valid if you use THM bottom bracket which are designed for the THM cranksets.
If you use non THM bearings please check if the width (see Specifications) of the
bearings allows for the cone sleeve to be installed in the correct position as described
in this chapter.
-
Locate the 1.0 mm spacer (4) ring on
the cone sleeve (3). (For T47 inboard
bottom bracket use a cone sleeve with
2.5 mm flange.)
-
Except for ITA there is no spacer needed
on the cone sleeve.
-
For BBright TM PressFit Road take a 2.0
mm spacer
-
Press the cone sleeve in the bearing
on the non-drive side (left)
-
Place a 2 mm spacer (6) ring onto the
axle. (see also p. 11 ff).
- For ITA and BBright PressFit Road use
a 1 mm spacer instead of 2 mm.
- Lightly grease the bearing seat of the
axle.
- Insert the axle of the right crank through
the bottom bracket up to its stop.
- Thoroughly degrease the axle and
crank multi-tooth segment.
- Make sure that the clamping screw (2)
is loosened or removed
- Fit the left crank arm to the multi-
tooth segment of the axle.
- Press the cranks together by hand as
far as possible. Both cranks abut
against the spacer rings.
WARNING
4
3
1
2
6