Think 3D STORMBEE S20, Руководство пользователя

Страница: 43 / 102

STORMBEE User Manual – Think 3D BVBA
Version N°1.1, last modified 30/09/2018
29
5. Go back to the LB2 controller and its tablet. You should now see the DJI A3 controller figure
and name appear in the app on the tablet. If not, the USB cable between the LB2 and the tablet
may be wrongly connected or even disconnected. If this is the case, simply unplug the USB
cable from the LB2 and plug it back in again. P
ress the “camera” button which should be
illuminated in blue.
6. Verify that the status LED of the LB2 is continuously green. If not, the LB2 might be powered
off, the RC connection signal of poor quality or the DJI A3 and LB2 not paired yet. For the latter
case, refer to the manual of the A3 flight controller for pairing it with a DJI LB2.
7. After pressing the blue camera button in the app, you should now see the main mission screen
of the app and the camera view of the FPV camera onboard the STORMBEE which is pointed
forward. A window will immediately open with the “Aircraft Status”. If you get a message that
the firmware is out of date, ignore it as only Think 3D or its authorised maintenance centres
may perform updates to ensure compatibility and correct settings are maintained. Verify
status elements (flight battery voltage STORMBEE, remote controller battery charge level, GPS,
compass…) are all green and OK.
NOTE It might take some time for the DJI A3 GPS to acquire a good signal and find its location
on the small window in the corner of the app. In the meantime, the supposed location
of the STORMBEE will be the last location where the DJI A3 GPS had a position lock.
NOTE If you have a good connection with the LB2 but can't see the FPV view. The DJI GO app
default settings is showing the feed from a digital camera connected to the HDMI port
of the LB2 air module. However, STORMBEE uses an analogue FPV camera connected
to the AV port of the LB2 air module which reduces latency at the cost of lower image
pixel resolution. Go to the settings menu and move the slider from HDMI to AV. In
addition, slide the bottom slider fully left to turn off HDMI completely (100%). If done
correctly, you should now see the camera view of the FPV camera.
NOTE If the compass status is not good, there might be metal in the ground or some other
electromagnetic emitting source nearby which disturbs the compass. Move the
STORMBEE to another location and verify that the error goes away. If the error persists
or if requested by the DJI app, perform the compass calibration procedure described
in the DJI A3 User Manual. The calibration procedure may also be required when the
pilot observes STORMBEE to be performing small circles during flight when it should
remain in hover (control sticks centred and P-GSP mode active).
CAUTION! If the RC remote control connection is not good, try to move the STORMBEE to another
location. Most interference comes from Wi-Fi routers in the vicinity. Be very cautious
when the signal is poor. The pilot should decide at his/her own discretion whether to
take-off/continue or not/land. If the signal becomes poor during flight, the DJI Go app
will show a pop-up window to inform the pilot of this.