Manual UPSW.doc
6/15
Version 2.11.14
11 Block
Diagram
Version Inverter priority
Version Grid priority
12 Safety
Information
12.1 General
information
Read the manual carefully before installing or operating the inverter. If you do not understand or are uncertain
about any operation or information please contact your dealer. Before installation you must be aware of local
standards and rules applicable to use such equipment. For installation and use of the inverter pay attention to
local applicable standards, all relevant safety guidelines and measures. These rules may be different to the infor-
mation’s provided in this manual.
High voltages up to 1200V inside the inverter! Never open the enclosure. High voltage may harm or even kill
persons or animals. Never touch wires or blank connectors. Do not operate the inverter with damaged or sub-
standard wiring.
Warning! While sleep mode is active the inverter AC-Output is active and high voltage is present at the AC-
Output. To detect a load the inverter is sending 230VAC-Pulses to the AC-Output.
Check local standards for lightning protection of inverter systems.
No other inverter output, AC-Generator or other AC-Source may be connected to the inverters AC-Output. The
inverter will be destroyed immediately!
The enclosure may heat up to 80°C! Never obstruct louvers nor place other items on the inverters enclosure. If
ventilation is not sufficient the unit may overheat and an automatic shut off may occur.
Even if DC-Wiring is not longer connected to the batteries, inbuilt large capacitors may hold Dc-Voltage for an
extended period of time. The inverter may only be opened by skilled and authorized personnel.
Modifications without a written permission from RIPEnergy AG means that warranty is lost immediately!
The inverter contains components which can produce arks and sparks. To prevent fire or explosion, do not install
or operate in compartments containing batteries or flammable materials. Never use or operate the unit where
there is danger of gas- or dust explosion.
After automatic shut down of the inverter because of any failure the inverter may switch ON automatic again. The
OFF period is depending on what causes the shut down and may vary from only seconds to several minutes.
YOUR CONNECTION TO SAFETY
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• info@thiele-kg
• www
.thiele-kg.de
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• info@thiele-kg
• www
.thiele-kg.de
YOUR CONNECTION TO SAFETY
klick to
www
u-s-v
YOUR CONNECTION TO SAFETY
klick to
www
ACDC-DCDC
YOUR CONNECTION TO SAFETY
klick to
www
SYSTEME
YOUR CONNECTION TO SAFETY
klick to
www
CONTACT
YOUR CONNECTION TO SAFETY
klick to
www
CALLBACK