D/^^/KEϲ<භϭϬ<
^/E'>W,^
Rev. 02 –13 October 2015
8
3.3
UPS input and output connection
Minimum 6AWG copper wires are required for the 6KVA, and 10AWG for 10KVA, including input/output
cables and battery cables.
1) Switch off all breakers before connecting cables.
2) Remove the cover of the terminals, refer to chapter 2.1, follow fig. 3-3 to connect the cables
Fig.3-3 I/O terminals connection
3) Connect the UPS output L, N, GND to L, N, GND of load via a PDU. Tighten the screws and shelter
the terminals
3.4
Connection of the UPS communication cables
1
˅
USB cable provided in accessories can be used to connect the UPS with PC
2
˅
Follow steps below to install SNMP (optional):
A. Remove the cover of SNMP slot at UPS rear panel and keep it for further use.
B. Insert the SNMP card and tighten the screws
C. Connect the UPS with internet by network cable.
D. Refer to the SNMP manual provided to do SNMP setting.
CAUTION!
Connector are required so as to ensure the connections have a better clamping.
Don’t reverse the input L and N.
Don’t connect the UPS input to a wall outlet or the outlet will get burnt.
YOUR CONNECTION TO SAFETY
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• www
.thiele-kg.de
Thiele KG
• V
orderer W
einberg 26 • D-71522 Backnang • T
el.: +49 (0)7191 3560-0
• Fax.: +49 (0)7191 3560-19
• www
.thiele-kg.de
YOUR CONNECTION TO SAFETY
klick to
www
u-s-v
YOUR CONNECTION TO SAFETY
klick to
www
ACDC-DCDC
YOUR CONNECTION TO SAFETY
klick to
www
SYSTEME
YOUR CONNECTION TO SAFETY
klick to
www
CONTACT
YOUR CONNECTION TO SAFETY
klick to
www
CALLBACK
