24
VLC-3 rev.04
VLC-3
currently defined light peaks, the program will jump to the dusk-to-dawn
programs. You can backtrack by turning the knob in the opposite
direction.
67(3
Press the push-button to step to the state.
State:
The program state is used to signal the end of the light peaks. As
long as the state is ON, the user can continue adding light peaks. When
a light peak is turned off, the user exits the light peak cycle and enters a
new period. The current state of the light peak flashes on the display.
Use the adjustment knob to set the state.
67(3
If the state is ON, push the push-button once to step to the start
time. Otherwise, push the push-button to exit programming mode.
Start time:
The start time is entered as a clock time. The hours value
flashes on the display. Use the adjustment knob to set the hours. Press
the push-button once. The minutes flash on the display. Use the adjust-
ment knob to set the minutes.
67(3
Press the push-button to step to the duration.
Duration:
The duration is the duration of the light peak. It is measured
in minutes and seconds and ranges from 0 to 15 minutes. Use the
adjustment knob to set the duration. When the duration is greater than
one minute, the adjustment knob increments the value in steps of five
seconds.
67(3
Press the push-button to step to the next light peak.
