26
VLC-3 rev.04
VLC-3
67(3
Press the push-button to enter the last day for this period.
Last day of period:
This is the last day for the current period. Use the
adjustment knob to adjust the value as required. If this is the last period
needed, the last day must be 365. If this is not done, the controller will
define an empty period ending on day 365.
67(3
Press the push-button to enter the dusk-to-dawn programs for this
period.
9.2.1 Dusk-to-Dawn Programs
Program number:
Programs are numbered from 1 to 12 for each period.
The display shows
dd . 1
where 1 (flashing) is the dusk-to-dawn program
number. If no programs have yet been entered in the controller, the user
must start by entering program 1. Otherwise, the user can select the
dusk-to-dawn program using the adjustment knob. If you turn the
adjustment knob past the currently defined programs, the program will
jump to the light peaks (i.e.
PE . 1
etc.). You can backtrack by turning
the knob in the opposite direction.
67(3
Press the push-button to step to the program state.
Program state:
The program state is used to signal the end of the dusk-
to-dawn programs. As long as the program state is ON, the user can
continue adding programs. When a dusk-to-dawn program is turned off,
the user exits the dusk-to-dawn program cycle and enters the light peak
cycle. The current state of the dusk-to-dawn program flashes on the
display. Use the adjustment knob to set the state of the program.
dd
