Thetford SANICON TURBO 300, Руководство по эксплуатации

Страница: 4 / 25

Sani-Con Model 300 - Portable Tank “Buddy”
4
www.thetford.com
Electrical Planning
2D
85 86
18G BLU 18G BLU
Fig. 2
Fig. 2
represents recommended wiring configuration. Other wir
-
ing configurations are possible based on your installation.
■
Pump requires a 12-VDC/35 AMP dedicated circuit with 35
AMP breaker or fuse between main bus or battery.
■
Wire size is dependent on distance between pump and
power source. Actual wire sizes should be calculated ac-
cording to installation.
The positive and negative wires should be braided to
prevent radio interference during operation.
NOTICE
While the pump is turned on, verify electrical system
by measuring voltage at motor; (must be 12V).
Improper installation may cause damage to motor or
decrease pump efficiency.
NOTICE
AVIS AVISO
CAUTION !
Pump Assembly
T000090C
2A
K4
2B
K1
K3
2C
Included in product
2D
Electrical System
Wire Gauge Size Chart
If Wire Gauge for distance from
source* is: 0-18 feet
(Included) 19-32 Feet 33-50 feet Circuit Breaker
12 VOLTS - Install 10 Gauge 8 Gauge 6 Gauge 35 amp
* Distance measured assumes power
and ground wires.
Fig. 3
Ref. Description
K1 Macerator Pump
K3 Macerator Switch
K4 35A Fuse/Breaker
Ref. Description
2A Battery
2B Relay
2C Over-Temperature Switch (90°C) normally closed
2D Ground