INSTALLATION
Regulations and Standards
In your own interest of safety, gas appliances should be installed by competent persons.
Failure to install the appliance correctly could invalidate any warranty or liability claims.
This appliance shall be installed in accordance with the manufacturers installation
instructions, local gas fitting regulations, municipal building codes, AG5601 and any other
relevant statutory regulations.
Data label.
The data label is located on the right hand side front of the oven compartment, behind the
oven door. A duplicate data label is supplied to adhere to an accessible area next to the
appliance. Ensure that the gas supply is Propane. This appliance is designed for use with
Propane gas and should not be converted for use with any other gas.
Ventilation
This appliance is suitable for installation into Holiday Homes, Touring Caravans and Boats.
In all cases the national standards with regard to ventilation for the particular vehicle into
which the appliance is to be installed must be adhered to.
The appliance
MUST
have a gas escape hole (min size 50mm Ø; max 70mm Ø; or
shaped hole of equivalent area – 1965 to 3850mm
2
) in the floor, directly beneath the
appliance and positioned at the rear as shown in Fig. 3. The hole
MUST
vent to the
outside and should be baffled to prevent direct draught to the appliance.
Location of Appliance
This appliance maybe installed in a kitchen/kitchen diner but NOT in a room containing a
bath or a shower. LP gas appliances must not be fitted below ground level. e.g. in a
basement.
Position
CAUTION: DO NOT LIFT APPLIANCE USING THE DOOR HANDLES
This appliance must be installed in such a way that the furniture fitted around the unit
follows the minimum dimensions as shown in Figs. 1. If this cannot be adhered to because
of design constraints, then the design is deemed permissible providing that the
temperature rise on the furniture is tested. The temperature rise must not exceed 65C
above the ambient temperature, or where applicable, must not exceed the maximum
allowable temperature, to avoid damage, as detailed within the material supplier’s
specification.
All combustible materials such as curtains and shelves must be kept well clear of the
appliance, their installation should meet all relevant local and national standards in force.
IMPORTANT
•
This appliance must be installed into an aperture, sealed off at either side in
order to prevent draughts from adjoining cupboards/vents. Ensure that air vents
and gas escape holes are kept clear, holes for cables and pipes must be sized to
minimize air leakage between compartments.
•
Under no circumstances should the ventilation hole exceed 3850mm
2
or other
low level ventilation be located in the compartment, including vents in kickboards.
Low level vents in adjacent compartments are permitted.
•
When installing the appliance at ‘Eye’ level, any cupboards beneath the
appliance
MUST
be sealed to prevent a gas escape entering the living area.
9
Содержание S~OG70000Z
Страница 2: ...2...
