MAINTENANCE
&
SERVICING
IMPORTANT
•
All servicing must be carried out by an approved competent person.
•
After each service the appliance must be checked for gas soundness
This appliance needs little maintenance other than cleaning. All parts should be cleaned
using warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders.
When cleaning the burner ring it is essential to ensure that the holes do not become
blocked.
The control knobs are a push fit and can be removed for cleaning. They are
interchangeable without affecting the sense of operation.
Who To Contact
For service, please contact your authorised local Service Agent giving full details of the
model, serial number and date of purchase.
1. Disconnect from gas supply
Lift and remove the bottom plinth to gain access, then disconnect the gas supply.
2.
Remove appliance from housing
Disconnect from gas supply (1). Open the oven door and remove the 2 screws from
each side trim. Carefully slide the appliance out one third and check for any
possible snagging of wires or pipes. If OK, lift appliance out onto a suitable surface.
3. Control replacement
Disconnect from gas supply (1). Remove appliance from housing (2).
Open the oven door and unscrew the 2 screws holding the thermostat probe in
position and push the probe back out through the hole in the rear of oven. Remove
the retaining screws from on top and underneath the control. Disconnect the inlet
pipe and two burner supply pipes. Remove the fittings off the old control and fit on
the replacement.
4.
Remove the grill burner
Disconnect from gas supply (1). Remove appliance from housing (2).
Open the oven door. Remove the three flue retaining screws – two beneath the
fascia panel, one located on top rear of flue cover. Lift off the flue cover. Lever off
starlock washers retaining the grill burner.
5.
Spark Ignition (where fitted)
Disconnect from gas supply (1). Remove appliance from housing (2).
Grill burner -
Remove the screw from the bracket and spark ignition probe in the
top of the burner. Trace the electrode wire back to the generator and pull off the
connector.
Oven burner -
Trace the electrode wire up the back of the cooker to the generator
and pull off the connector. Unscrew the fixing screw on the spark electrode inside
the oven cavity, then carefully pull the electrode from inside the oven and remove.
Piezo Electric Generator –
Remove all electrode wires. Remove the lock nut and
carefully remove from panel.
11
Содержание S~OG70000Z
Страница 2: ...2...
