SERVICE AND MAINTENANCE
30
REMOVING THE LOWER AXIS
Remove the protection cover of the
transmission system.
Remove the two gears from the axes by
unscrewing the headless inserted screws keeping
them in place. You do not need to unmake the
chain! Remove them all together with the chain.
Unscrew the four nuts keeping the motor in
place and remove it (see Fig 12).
Remove the support disk and the feeder.
When putting back together, it is absolutely
necessary to put the rubber gasket at its position!
Fig 12.
Removing the lower axis
7.5.3.
Service after power blackout
In case there is a power blackout, it is absolutely necessary to perform some checks and take
some safety measures to avoid overheating. The solid fuel has all the time a certain amount of
fuel in the fire chamber, which will not stop burning immediately.
Turn the control panel to OFF.
When the power is restored, turn on the control panel and make sure all the devices function
properly.
7.5.4.
Replacement of the ignition element
In case you need to replace the ignition element follow the instructions:
Turn OFF the control panel and disconnect from electricity.
Disconnect the connection wires of the ignition element from the control panel and loosen the
plastic tap holding them in place.
Remove the fan by unscrewing the four screws keeping it in place.
Remove the ignition element from the tube and insert in position the new one. Push the
ignition element to ensure it is positioned at the end of the tube.
Pull the cables of the ignition element through the provided hole, tighten the plastic tap and
connect the ignition element to the control panel.
Fig 13.
Removing the ignition element
