Page
21
Installation, use and maintenance guide
Urban
– Urban E
8.3 REPLACING THE BATTERY OF THE REMOTE CONTROL
When the infrared remote control does not send out the transmission signal (the led comes not on), the battery must be replaced.
Using a suitably sized Philips screwdriver, undo the screw of the battery cover on the back of the remote control and replace the
battery. The dead battery must be disposed of in compliance with the regulations in force.
8.4 REPLACING THE BATTERY OF THE CONTROL PANEL
Inside the control panel there is a buffer battery type CR1632. When the time and programming are not being memorised, then the
battery needs replacing. Proceed as follows:
-
Switch off the appliance and unplug the power cable from the power source.
-
Remove the cover by pressing your fingers towards the centre in order to press the two tabs
A
and
B
as illustrated in the
following figure.
-
Pull the top cover outwards and replace the battery. The dead battery must be disposed of in compliance with the regulations
in force.
FIGURE - 7
FIGURE - 8
FIGURE
–
9
FIGURE
–
10
A
B
C3
C4
